6
1. OBSERVE SAFETY INSTRUCTIONS
•
Make sure you have read and understood the whole instruction
manual before installing, operating or carrying out any maintenance
on this unit.
•
Warnings and serial label on the unit provide important directions
and information on the safe use of the unit.
•
In addition to these operating and safety instructions please make
sure that all accident prevention regulations applicable in the
country of use are followed.
•
In addition to these operating and safety instructions any standards relating to the installation and
operation of high pressure cleaners applicable in your country must be strictly followed.
•
This unit is not intended for use by children. Children must always be supervised when in the
vicinity and ensure that they DO NOT play with the unit. Further, it is not intended for use by
persons with reduced physical, sensory or mental capabilities, or lack of experience or
knowledge. It must only be operated by persons instructed in its use who have been especially
authorized to do so.
•
DO NOT operate the unit without appropriate personal protective equipment PPE.
2. ELECTRICAL CONNECTION
•
The voltage, hertz rating and number of phases on the serial label
must correspond to that of the electrical mains outlet.
•
Only connect the unit to electrical installation made by
certified
electrician and comply with IEC 60364-1.
•
It is recommended that the electrical supply to this unit should
include either a residual current device that will interrupt the
supply if the leakage current to earth
exceeds 30mA for 30 ms
or
a device that will prove the earth circuit.
•
Switching on the unit may cause voltage fluctuations. Voltage
fluctuations should not occur if the impedance of the transfer point
is less than 0.15Ω. If in doubt contact your power supplier.
•
This Class 1 Appliance must only be connected to an earthed
power supply fitted with an appropriately sized fuse.
3. POWER CORD
•
Make sure before every use that the power cord assembly is not
damaged or cut. If it is DO NOT connect the unit, have it replaced
by an electrician or authorized service technician.
(Type Y
attachment)
•
DO NOT pull on the power cord in order to unplug the unit,
remove the plug from the power outlet.
GENERAL SAFETY PRECAUTIONS
30mA
