Model
XE526SE
Work
Troubleshooting
The part 4.
The Drive Belt
Rev.
Procedures
：
1.
If the belt falls off, take apart the right
side case and loosen the idler wheel and
resume the belt. Turn the drive pulley
slowly and check the displacement and
the alignment of the belt, drive pulley
and the flywheel. Then turn the drive
pulley with the speed between 100 and
120 rpm with sudden stop. If the belt
runs normally, resume all parts, as
shown in figure 1.
2.
If the belt, drive pulley and the flywheel
do not align well, adjust the flywheel to
the proper position, as shown in figure 2.
3.
If the belt slips, refer to procedure 6 and
use 13mm wrench to adjust the nut on
the J-bolt as shown in figure 3.
1
2
3
