10
STEP 4: CONSOLE, SEAT, COVERS, PEDALS
1. Install the front and rear stabilizer covers (32 & 37) and secure to the frame with four M5 x 12mm
screws (99).
2. Install the left and right cup holders (39 & 38) to the rear handlebars with four self tapping screws
(105).
3. Install the bottom seat cushion (61) to the seat carriage (4) with four M6 x 15mm screws (98).
4. Install the Pedals (116 L, 117 R) into the Crank arms (51L, 51R). Remember that the left pedal has
a reverse thread and will be screwed into the crank in the opposite rotation from normal threads.
There is an
stamped into the end of the threaded post of the left pedal and an
in the right.
Make sure to tighten the pedals as much as you possibly can. It may be necessary to re-tighten the
pedals if you feel a thumping during pedaling the bike. A clicking noise, or thumping, sound during
pedaling is usually caused by the pedals being too loose.
5. Connect the two wire harnesses (44 & 45) to the corresponding connectors on the back of the
console. Install the console onto the console mast and secure with four M5 x 12mm screws being
careful to not pinch the wires.
Summary of Contents for Recumbent
Page 7: ...6 Tools 114 Phillips Screw Driver 1 pc 112 12 14mm Wrench 1 pc 132 14 15mm Wrench 1 pc ...
Page 13: ...12 Tools 93 Phillips Screw Driver 1pc 100 12 14mm Wrench 1pc 117 13 15mm Wrench 1pc ...
Page 34: ...33 Recumbent Exploded View Diagram ...
