Customer Service 1-888-707-1880
Dyaco Canada Inc. 2020
Email: [email protected]
29
GENERAL
MAINTENANCE
Wipe down all areas in the sweat path with a damp cloth after each workout.
2. If a squeak, thump, clicking or rough feeling develops the main cause is most likely one of two
reasons:
a. The hardware was not sufficiently tightened during assembly. All bolts that were
installed during assembly need to be tightened as much as possible. It may be
necessary to use a larger wrench than the one provided if you cannot tighten the
bolts sufficiently. I cannot stress this point enough; 90% of calls to the service
department for noise issues can be traced to loose hardware.
b. The crank arm nut needs to be retightened
c. If squeaks or other noises persist, check that the unit is properly leveled. There are
2 leveling pads on the bottom of the rear stabilizer.
Use a 14mm wrench (or
adjustable wrench) to adjust the levelers.
ENGINEERING MODE
The console has built in maintenance/diagnostic software. The software will allow you to change the
console settings from English to Metric and turn off the beeping of the speaker when a button is
pressed for example. To enter the Engineering Mode Menu, press and hold down the Start, Stop
and Enter buttons. Keep holding the buttons down for about 5 seconds and the Message Center will
display Engineering Mode Menu. Press the Enter button to access the menu below:
1. Key Test (Will allow you to test all the keys to make sure they are functioning)
2. Display Test (Tests all the display functions)
3. Function
- Units - Sets the display to read out in Imperial (miles, pounds, feet, etc.) or Metric (kilometers,
kilograms, meters, etc.) display measurements
- Pause mode (have five minutes)
- Odometer Reset (Resets the odometer)
- Beep sound (Control Beep)
4. Service
- PWM test (Test the Brake resistance)
- Csafe test
- Sensor test (Test the speed sensor function)
5. Exit