CUSTOMER SERVICE 1-888-707-1880 Dyaco Canada Inc. ©2013
6
STEP 1 :
Rail Assembly & Console Mast
1. Locate the Console Mast
(12)
and Console Mast Cover
(72)
; slide the Cover onto the Mast
as far as it will go. Make sure the Console Mast Cover
(72)
is facing the correct way.
2. At the top opening of the Main Frame
(1)
, there is a
Resistance Connecting Cable
(50)
tied to a twist tie wire. Feed the twist tie wire and
Resistance Connecting Cable
(50)
into
the bottom of the Console Mast
(12)
and out of the opening at the top.
3. Install the Console Mast
(12)
into the receiving bracket on the top of the Main Frame
(1)
. Be
extremely careful not to pinch the cables between the tubing. If the cable gets pinched, this
may affect the electrical functions of the console.
NOTE:
there is one bolt already installed
in the receiving bracket that will engage with the slot at the bottom of the Console Mast.
This needs to be tightened last, after the three other console mast bolts.
4. Place a Split Washer
(152)
onto the Hex Head Bolt
(105)
and hand tighten through the left
side of the console mast. Place a Curved Washer
(153)
onto each Hex Head Bolt
(103)
and
thread both into the front of the console mast tube. Fasten these front bolts as tight as
possible with the Wrench
(155).
Next firmly tighten the two left side bolts with the same
wrench.
5. Connect the two Hand Pulse Cables
(48)
,
Computer Cable
(44)
, and
Resistance
Connecting Cable
(50)
to the back of the console
(43)
. Do not force the connectors; they
will only fit one way and are different sizes to prevent confusion. Store the excessive cable
in the Console Mast tube
(12)
.
6. Attach the Console
(43)
to the bracket of the Console Mast tube with four Phillips Head
Screws
(116)
. Tighten the screws with the Phillips Head Screw Driver
(157)
.
7. Attach the
Rear Rail Assembly
(15)
to the rails
(2)
with two Button Head Socket Bolts
(176)
and Curved Washers
(153)
on each side. Tighten using the Combination M5 Allen Wrench
& Phillips Head Screw Driver
(177)
.
8. Slide the Rail Assembly into the Main Frame
(1)
. Insert one Button Head Socket Bolt
(176)
through each side and attach a Flat Washer
(137)
and a Nyloc Nut
(130)
to each joint on the
inside.
HARDWARE
#137.
3/8" × 19 × 1.5T
Flat Washer (2 pcs)
#153.
3/8" × 23 × 2T
Curved Washer (6 pcs)
#116.
M5 × 10m/m
Phillips Head Screw
(4 pcs)
#152.
3/8" × 2T
Spilt Washer (1 pc)
#103.
3/8" × 3/4"
Hex Head Bolt (2 pcs)
#130.
3/8" × 7T
Nyloc Nut (2 pcs)
#105.
3/8" × 2-1/4"
Hex Head Bolt (1 pc)
#176.
3/8" × 2-1/4"
Button Head Socket Bolt
(6 pcs)
