CUSTOMER SERVICE 1-888-707-1880 Dyaco Canada Inc. ©2013
23
General Maintenance
1. Wipe down all areas in the sweat path with a damp cloth after each workout.
2. If a squeak, thump, clicking or rough feeling develops the main cause is most likely one
of two reasons:
I. The hardware was not sufficiently tightened during assembly. All bolts that were installed during
assembly need to be tightened as much as possible. It may be necessary to use a larger wrench
than the one provided if you cannot tighten the bolts sufficiently. I cannot stress this point enough;
90% of calls to the service department for noise issues can be traced to loose hardware or the rear
rails being dirty.
II. Dirt build-up on the rear rails and polyurethane wheels are also a source of noise. Noise from
build-up on the rails can cause a thumping sound that you would swear is coming from inside the
main body of the machine because noise travels, and is amplified, in the tubing of the frame. Clean
the rails and wheels with a lint free cloth and rubbing alcohol. Stubborn build-up can be removed
with your thumbnail or a nonmetallic scraper, like the back edge of a plastic knife. After cleaning,
apply a small amount of lubricant on the rails with your fingers or a lint free cloth. You only need a
thin coat of lubrication, wipe off any excess.
3. If squeaks or other noises persist, check that the unit is properly leveled. There are 4 leveling pads
on the bottom of the rear rails, use a 14mm wrench (or adjustable wrench) to adjust the levelers.
Engineering Mode Menu
The console has built in maintenance/diagnostic software. The software will allow you to
change the console settings from English to Metric and turn off the beeping of the speaker
when a key is pressed for example. To enter the Engineering Mode Menu, press and hold
down the
Start
,
Stop
and
Enter
keys. Keep holding the keys down for about 5 seconds and
the Message Center will display Engineering Mode Menu. Press the
Enter
button to access
the menu below:
a. Key Test (Will allow you to test all the keys to make sure they are functioning)
b. LCD Test (Tests all the display functions)
c. Functions (Press
Enter
to access settings and
Up
arrow to scroll)
i. Sleep Mode (Turn on to have the console power down automatically after 20
minutes of inactivity)
ii. Pause Mode (Turn on allow 5 minutes of pause, turn off to have the console pause
indefinitely)
iii. ODO Reset (Resets the odometer)
iv. Unit Type (Press enter to select ENGLISH or METRIC)
v. Beep (Turns off the speaker so no beeping sound is heard)
vi. Motor Test (Press
Enter
to run the resistance motor up and down in a continuous
loop. Display shows level setting and position sensor reading. Press
Stop
to end
test.)
vii. Safety
viii. Elliptical/Bike
ix. Incline On/Off (For e
-
Glide this is always off)
d. Security (Allows the keypad to be locked to prevent unauthorized use)
