Spirit Commercial CRW800H2O, Owner'S Manual

Page: 17 / 40

17
www.spiritfitness.com
How to Fill and Empty the Tank
1.
Remove the Fill Plug (No. 50) from the Upper Tank (No. 24)
.
2. To fill tank with water, refer to Fig. A. Insert the
Funnel (No. 52) into the
tank, then use a cup or the
Siphon Pump (No. 53)
and a bucket to fill
the tank. Use the water level gauge on the side of the tank to measure
desired water level in the tank.
3. To empty the tank, refer to Fig. B. Place a bucket next to the rower, and
use the Siphon Pump (No 53)
to pump out the water from the tank into
the bucket.
4. Insert the
Fill Plug (No. 50) into the Upper Tank (No. 24)
. Wipe excess
water off of the frame.
NOTE:
•
Fill the tank only with tap water. Add 1 water-purification tablet (1 packet
is included.). Never use pool chlorine or chlorine bleach. This will
damage the tank and void the warranty.
50
53
52
24
Fig. A
Fig. B
Water level label
50
24
50
53
52
24
Fig. A
Fig. B
Water level label
50
24
•
Add a water purification tablet every 6 months or as needed. If water remains
cloudy, replace the water in the tank.
•
Water from the tank is not suitable for consumption. Dispose the water after
pumping it out from the tank.
WATER LEVEL
•
See Fig. A. The water level gauge is on the side of the tank. The maximum fill level is 6. Never fill it over this
limit. Filling the tank over this limit will void the warranty.
•
The resistance depends on the water level in the tank. Water level 1 is the lowest resistance. Level 6 is the
highest resistance.