Spirit Commercial CRW800H2O, Owner'S Manual

Page: 10 / 40

10
Spirit Fitness
CRW800H2O
PRE-ASSEMBLY
Use the following procedures to unpack and assemble your water rower manufactured by Spirit Fitness:
1. Position the shipping carton so the heavy end is located at the bottom.
2. Cut the straps then lift the box over the unit and unpack. Remove foam inserts and all parts from the shipping
carton, then use the parts list to verify that all parts are included in your shipment.
3. Locate the hardware package. The hardware is separated into steps. Remove the tools first. Remove the hardware
for each step as needed to avoid confusion. As you read through the assembly instructions, any number that is in
brackets [#] refers to the item number from the corresponding assembling drawing.
NOTE: All tools required to assemble the rower are included within the packaging.
NOTE: If you are missing any of the parts listed above, inspect the packing material and the box for items that may
have been overlooked.
If parts are missing, or if you have any operational questions, please call your local Spirit Fitness’s service department
or the distributor whom sold you the product. Please see the back of the manual for a listing of international corporate
offices and locate the office nearest you. Have your serial number ready.
CAUTION: Damage to the rower during assembly is not covered as part of the limited Spirit Fitness warranty. Take
care not to drop or lean the rower on its side. Carefully stand the rower up in the normal upright position on a stable
surface so it will not tip over during assembly.
Protect the environment by not disposing of this product with household waste. Check your local authority or approved
waste center for recycling advice and facilities.