© 2018 Spireon, Inc.
6
/
12
Green
Cellular
Connection
On:
Indicates cellulardata connection is available
Flash Slow
: cellular subsystem initialized but no
connection
Flash Fast
: cellular initialization in process
Off:
Cellular sub-system is off
Orange
Battery
charging
On:
Indicates external power and battery is fully
charged
Flash
: Indicates external power and battery is charging
Off
: Indicates running from battery. Blinks shortly every
30sec.
The JG-LS provides user control allowing the LEDs to be extinguished once
installation is verified. This feature reduces power and further conceals the JG-LS
Tracker from untrained parties wishing to defeat its operation.
Accelerometer
The accelerometer is used for motion start detection to wake the unit up from a sleep
mode and driving behavior monitoring.
UART
A UART port is provided for AT command and data interaction. The UART can also
serve to attach other accessories, such as cargo sensor.
1-Wire
A 1-Wire interface is supported to attach external sensors, such as temperature
sensor, etc.
Relay Driver
A 500mA sink capable output pin is provided. This pin is meant to drive a relay coil
indented to operate a door opening device.
Ignition Monitor
One of the GPIO’s can be wired to vehicle ignition to monitor and trigger event upon
ignition start and stop.
Power Out
The JG-L provides a power out option at 3.3V and up to 1A to enable powering up
external devices. The power out is turned off by default and is controlled by software.
Tamper
Tamper detection pin is available on the external connector. The Tamper pin can
trigger an alert when disconnected from ground.
Solar Panel
