Spire 860-0032, Installation Instructions And Use & Care Manual

Page: 23 / 74

5. Reinsert the burner and reattach using the cotter clip and
screws previously removed. Repeat the procedure for
each main burner.
6. Position the igniters so they are 3.2 mm / 1/8 in away from
each burner.
23
Change The Rear Burner Orifice
1. Use a screwdriver to remove the two screws from the rear
burner heat shield. Remove the heat shield.
2. Unscrew from the rear burner cover and remove the sear
burner rear cover.
3. Use an adjustable wrench to remove the brass elbow.
4. Use a 6 mm socket wrench or 6 mm nut driver to remove
the orifice. Replace with the corresponding natural gas
orifice.
IMPORTANT: Check that the NG orifice is properly
installed inside the valve.