Data subject to change without notice
│
M36311
│
Issue F
www.spinner-group.com
5 / 18
24. All externally connected circuits for control, alarm and signalling must be supplied by SELV power sources (SELV
according to DIN EN 60950-1). The current in these circuits must be limited to the values specified in the product
documentation by means on an external fuse.
25. Before applying RF power to the product, it must be ensured that all connecting elements are professionally
connected and all unused ports are terminated. RF connections must have sufficient mechanical strength. If the
product features an interlock system, it must be connected and tested for function in advance.
26. Unless expressly permitted, never remove the cover or any part of the housing while the product is in operation.
Doing so will expose circuits and components and can lead to injuries, fire or damage to the product.
27. Repairs must be carried out by the manufacturer or technical personnel authorized by the manufacturer only.
28. As with all industrially manufactured goods, the use of substances that induce an allergic reaction (allergens) such
as nickel cannot be generally excluded. If you develop an allergic reaction (such as a skin rash, frequent sneezing,
red eyes or respiratory difficulties) when using a SPINNER product, consult a physician immediately to determine
the cause and to prevent health problems or stress.
29. Broadcasting systems or improper use of this product may produce an elevated level of electromagnetic radiation.
Considering that unborn babies require increased protection, pregnant women must be protected by appropriate
measures. Persons with pacemakers may also be exposed to risks from electromagnetic radiation. The
employer/operator must evaluate workplaces where there is a special risk of exposure to radiation and, if
necessary, take measures to avert the potential danger.
30. In the event of a fire, the product may release hazardous substances (gases, fluids, etc.) that can cause health
problems. Suitable measures must be taken, e.g. wearing of protective masks and protective clothing.
31. Products in operation may be hot. Touching them might cause burns.
32. If the product is pressurized, applicable local or national safety regulations for pressure equipment must be
observed.
33. Blocking of constructive openings on the product (ventilation slots, fine leaks etc.) must be prevented to ensure
safe operation.
34. Before cleaning, disconnect the product and all transmitters connected to the product from mains. Use a soft, but
not damp lint-free duster for cleaning. Do not use any chemical cleaning agents.
35. If handling the product releases hazardous substances or fuels that must be disposed of in a special way, e.g.
coolants that must be replenished regularly, the safety instructions of the manufacturer of the hazardous
substances and the applicable regional waste disposal regulations must be observed. Also observe the relevant
safety instructions in the product documentation. The improper disposal of hazardous substances can cause health
problems and lead to environmental damage.
36. The operator is responsible for disposing of the product according to national waste disposal regulations. Improper
disassembly or disposal may be hazardous.
37. SPINNER RF switches are not equipped with separating equipment for safe disconnection from mains. The user
must provide external separation equipment. The mains connector must be de-energized during plugging.
38. Do not actuate RF position
I
and RF position
II
of RF switches simultaneously to avoid RF switch damage.
39. Do not touch or block the emergency manual override during electrical switch over to avoid injuries and switch
damage.
40. Disconnect RF switches from mains before using the emergency manual override of the drive unit to avoid injuries
and switch damage. The emergency manual override serves solely for switching the RF switch manually in a dead
state.
41. Switch over RF switches only without applying RF power to avoid injuries and damage. Hot switching with RF on
is not permitted. Ensure all switches are in the respective end position before applying RF power.
42. Switch off RF power before disconnecting RF connectors to avoid burns, eye injuries and electric shock. Utilize
appropriate devices and methods to prevent accidental energizing.
