Copyright © 2020 Spiker Engineering. All Rights Reserved.
Take the supplied M6 screw and slip it through the mounting bracket as shown. Next, install either one or both of
the supplied standoff(s) over the screw, behind the bracket, as noted below.
Note:
Use
both
standoffs for
’01-04 Tacoma, and only the
long
standoff for ’05-15 Tacoma.
Install the bracket over the handle, and thread the M6 screw into the a-pillar (do not fully tighten the screw at this
point):
The recommended Ultragauge mounting method is to use the bracket supplied with each Ultragauge, although Dual
Lock mounting is also an option. If you do not have the Ultragauge bracket, you can contact Ultragauge for a
replacement, purchase one from them, or use a Dual Lock strip (available from us free of charge).
Prepare the bracket by drilling an 1/8” hole near the top of the slot, as shown in the red circle below.
Install the Mounting Bracket
