Operation manual - Spider ILD01G
27 / 54
rev. 03-01-04-2019
10 OPERATION
10.1 TRANSPORTING THE MOWER
The mower should be transported to the mowing area on a trailer or other suitable transport vehicle.
Transporting the mower on thoroughfares on its own wheels is prohibited
When loading/unloading a trailer, make sure that the edge - formed by the floor of the trailer and the ramps
– is
not an obstacle for the mower. Otherwise you need to use longer ramps.
When loading, do not allow any person to stand by the ramps or under the hanging mower if it is lifted. It may
only be hung up on places marked by the chain symbol. The loading capacity of the lifting eyes/ hooks must be
suitable for the weight of the machine as quoted on the serial plate.
When transporting the mower, make sure it is properly secured. Attach fastening devices to the hoist rings
marked by the chain symbol on the mower.
10.2 STARTING THE ENGINE OF THE MOWER
•
Check the gasoline in the fuel tank, refuel with
unleaded gasoline BA95 if necessary.
•
Check the forward/reverse control joystick (8)
on the remote radio controller and leave it the
neutral position.
•
Switch ON the remote radio controller power
switch (1) by turning clockwise.
•
A red lamp (11) will illuminate on the RC.
Unless button (1) is in the ON
position, the machine will not start
•
Ensure the EMERGENCY STOP button (1) on
the remote radio control is in the raised
position.
•
Use the key to unlock and pull up the
EMERGENCY STOP button on the mower
•
Set the engine choke control to the position for
cold start - the lever is pulled up (only for the
first start or if the engine is cold). See the
engine user’s manual.
•
Wait till lamps 1 and 3 are illuminated and lamp
2 is flashing (on the mower), then press the
horn button (12) on the remote radio controller
– the mower ignition engages.
•
Press the START button (4) on the remote
radio controller. If the engine does not start, all
the functions of the mower are locked again. To
unlock them and consequently to start the
engine,
press
button
(3).
After
three
unsuccessful starting cycles machine is locked,
wait for one minute.
•
The engine is
“running”, release the START
button on the remote radio controller. While the
engine is working do not use the START button
again.
•
Let the mower idle for about 2
– 3 minutes
without engaging the mowing device and, while
the engine is warming up, push back the choke
control (in the case of a cold start)
NOTICE:
Do not stand in direction where the
mower may move while starting it
Battery
