SPHINX
Project 32
10
Another press on the SETUP button selects:
Sphinx Control
Here you may select whether the Project Thirty-two
should react to incoming Standby commands from
other Sphinx equipment (“ON”) or that it will remain
switched on (“OFF”).
Another press on the SETUP button selects:
Repeat
Here you may select whether the CD will play Track
1 again after finishing the last track or whether the
replay will stop: “OFF”.
Another press on the SETUP button selects:
Output Level
This special mode enables you to attenuate the
output level by 6 dB. In some cases this might be
necessary - for instance when the input sensitivity of
the pre-amp is very high – to prevent possible
distortion on signal peaks.
This mode is unique while the actual attenuation is
done in the
digital
domain! This will ensure
maximum signal integrity.
Another press on the SETUP button ends the
Set-up
mode. The display now shows the same information
as on the moment you pressed the SETUP button
for the first time.
Note
: You may end
Set-up
mode at any time by
pressing the STANDBY button.
REPEAT: Off
CONTROL-IN: ON
OUTPUT: 0 dB
OUTPUT: -6 dB
