signals, the load is switched on. This mode enables fast check of the correctness of
system installation during installation debugging.
17
Normal on mode
The energized load keeps outputting, and this mode is suitable for loads which need 24-
hour power supply.
3.4.2 Load mode adjustment
Users can adjust the load mode as needed on their own, and the default mode
is Manual mode (see "load modes introduction"). The method for adjusting
load modes is as follows:
3.4.3 Manual load on/ off page
Manual operation is effective only when the load mode is manual mode (15), and tap the Set key to switch on/
off the load under any main interface.
3.5 System Parameter Settings
Under any interface other than load modes, press and hold the Set key to enter into the parameter setting interface.
After entering into the setting interface, tap the Set key to switch the menu for setting, and tap the Up or Down key to
increase or decrease the parameter value in the menu. Then tap the Return key to exit (without saving parameter
setting), or press and hold the Set key to save setting and exit.
Load mode
Press and hold the
Set key to enter
Tap the Return key to
exit without saving
Tap the Up or Down
key to set the mode
Press and hold the Set key
to save and exit
Battery type
System voltage
Equalizing voltage
Boost voltage
Over-discharge voltage
Over-discharge return voltage
Floating charging voltage
More information https://www.caravansplus.com.au
