EN
7
10. Place a pitch gauge on a main rotor blade and zero it out.
• Align the blade with the roll axis, apply full right cyclic, and adjust the
AFR until your pitch gauge reads 12.5.
• Align the blade with the pitch axis and zero the pitch gauge. Apply full
aft cyclic, and adjust the AFR until your pitch gauge reads 12.5.
11. Adjust the
Collective AFR
to set your desired collective pitch range.
Remove the pitch gauge.
Select
Back
twice to return to the
Setup
menu. The swashplate setup is
complete.
12. Navigate to the
Tailrotor
Output Setup
menu.
13. Set the
Frame Rate
to the operating frequency specified by your tail rotor
servo manufacturer.
14. Connect the tail rotor servo to Slot 5 and navigate to the
Direction
menu.
Move the tail rotor stick on the transmitter to the right and ensure the
tail rotor servo is moving the correct direction. If not, reverse the channel
direction on the FC6250HX.
Select
Back
to return to the previous menu.
15. Select
Subtrim
to center the tail rotor servo.
Select
Back
to return to the previous menu.
16. Select the
Travel
menu.
• Select
Left
travel. Hold the transmitter tail rotor stick full left, and
adjust travel to ensure full travel and that no binding occurs.
• Select the
Right
travel. Hold the transmitter tail rotor stick full right,
and adjust travel to ensure full travel and that no binding occurs.
TIP:
90% to 100% is recommended to achieve optimal flight
performance.
Press
Back
twice to return to the
Setup
menu. Tailrotor setup is complete.
WARNING:
Always remove the pinion gear or disconnect the main
drive motor from the ESC to disengage the drive system during
initial setup. The main rotor blades may turn in response to setup changes or
transmitter inputs. Failure to do so could result in serious personal injury or
property damage.
Tail Rotor Servo
