Instructions
1. Connect all of your radio gear and center your transmitter trims. Now find
the heavy duty servo control horns that came with your servos. Place the
control horns on each servo so that the control horns angle back at about
a 45 degree angle. Cut the other side of the horn off that you don’t need.
2. Use a Xacto knife to cut SHALLOW traces from each servo and the speed
control to the receiver cutout. This is slit is used to bury the servo and
ESC leads.
3. Now hot glue in the servos. Make sure to press the servos all the way in
the cutouts until the glue hardens. Using your fingernail, press the servo
leads into the slits you just cut.
