SpeedEPart Agri-Fab 45-0175, Owner'S Manual

Page: 5 / 12

5
FIGURE 5
9. Assemble the latch stand plate and the latch stand
bracket to the bottom of the poly tray using four 1/4"
x 3/4" hex bolts, 1/4" flat washers and 1/4" hex nuts.
The aligning tab on the bottom of the latch stand
bracket must be towards the rear of the cart.
Tighten.
See figure 6.
FIGURE 7
7. Assemble the axle and drawbar tongue to the wheel
support, with the open side of tongue facing away
from the wheel support. Fasten the axle to the wheel
support using four 1/4" x 1-3/4" hex bolts and 1/4" hex
nuts.
Tighten. See figure 4.
FIGURE 6
10. Place the poly tray down onto the wheel support,
positioning it so that the latch stand bracket snaps
under the latch lock lever. Fasten the tray to the
wheel support using eight 5/16" x 3/4" truss head
bolts and 5/16" hex nuts as shown in figure 7.
Tighten.
FIGURE 4
8. Assemble a spacer tube, a 1" flat washer, a wheel
(valve stem facing out) and another 1" flat washer
onto the axle as shown in figure 5. Insert a cotter pin
through the axle, spreading the ends. Repeat on
other end of axle.
NOTE: Use the grease fitting to fill the wheel hub with
automotive type grease after the wheel is assembled
onto the axle.
AXLE
WHEEL
SUPPORT
DRAW BAR
TONGUE
1/4" x 1-3/4"
HEX BOLT
1/4" HEX NUT
COTTER PIN
WHEEL
FLAT
WASHER
FLAT
WASHER
AXLE
SPACER
TUBE
1/4" FLAT
WASHER
1/4" HEX NUT
1/4" x 3/4"
HEX BOLT
LATCH STAND
BRACKET
LATCH
STAND PLATE
5/16" HEX
NUT
5/16" x 3/4"
TRUSS HEAD
BOLT
LATCH LOCK
LEVER