SpeeCo PS35TKO-1, Instruction Manual

Page: 9 / 112

9
Safety InfORMatIOn
• NEVER split a log heavier than 100 lbs in horizontal position .
• ALWAYS set up the log splitter in a clear, level area . Failure to do so can result in instability of the log splitter .
• ALWAYS block the wheels to prevent movement of the log splitter while in operation .
• KNOW how to stop the log splitter and disengage the controls before operating it .
• NEVER place hands or feet between the log and splitting wedge during forward or reverse strokes as this could result in
serious injury or death .
• NEVER straddle or step over the log splitter during operation .
• NEVER reach or bend over the log splitter to pick up a log .
• NEVER split more than one log at a time .
• NEVER try to split a log across the grain .
• NEVER attempt to load the log splitter when the ram or wedge is in motion .
• NEVER use your foot, a rope, or any extension device to operate the control lever on the valve . Only use hand .
• NEVER move the log splitter while the engine is running . Shut off the engine if you are leaving the log splitter, even for a
short period of time .
• NEVER touch the muffler and hot areas of the engine during operation . Wait until the engine cools down .
General Repair
WaRnIng
• NEVER alter your log splitter in any manner . Such alterations may cause your log splitter to be unsafe and will void the
warranty .
• NEVER tamper with the engine to run it at excessive speeds . The maximum engine speed is preset by the manufacturer,
and is set within safety limits . Running the engine at excessive speeds will void the warranty . Refer to the engine owner’s
manual for your particular log splitter .
• NEVER perform any service or repair on your log splitter without first removing the spark plug wire .
• ALWAYS replace all damaged or worn parts immediately .
• ALWAYS be sure that all replacement parts meet manufacturer’s specifications .
CaUtIOn
• NEVER operate your log splitter when it is in poor mechanical condition or in need of repair .
• ALWAYS perform all recommended maintenance procedures before using your log splitter .
nOtICe
• ALWAYS check the level of hydraulic oil and engine oil before operation .
• ALWAYS periodically check that all nuts, bolts, screws, hydraulic fittings and hose clamps are tight .