FOR PARTS AND SERVICE 1-800-290-2833
Page 16
MAINTENANCE / SERVICE
Brush Motor Replacement
On rare occasions the brush motor may need to be replaced. Please call Spec-
trum at 1-800-290-2833 to troubleshoot and see if your brush motor needs to
be replaced.
You
do not
need to remove either of the plastic tanks for motor replacement.
It is easiest to replace the brush motor with the Mopit on its back.
You will need a Phillips screw driver, 5/32, 1/8, and 3/16 Allen wrenches
1. Follow the steps on page 11 to remove the belt
2. Remove the two pulleys by using a 1/8 Allen wrench to remove the set
screws
3. Remove the six Allen bolts using a 5/32 Allen wrench
4. Pull the brush motor plate out of the machine. There is enough wire on the
brush motor so you should be able to set the whole assembly on the
ground without disconnecting the wiring.
5. Remove the two motor screws using a 1/8 Allen wrench
6. Replacement is the above steps in reverse
7. HINTS:
Make sure
that the motor pulley
is touching only the
motor shaft, not the
motor base. Make
sure that you tighten
the set screws onto
the flats of the brush
and motor shafts.
Make sure to replace
the motor spacing
block behind these
two screws.