Mid-Support Leg Assembly
1. Install the (2) glides onto the bottom of the leg. The
glides can be adjusted later to level the console.
2.
Align the mid-support leg and wall filler panel mounting
holes as shown.
Figure 6
.
3.
Attach the mid-support leg to the wall filler panels with
(4) 1/4-20 x 15mm JC bolts.
4. Set both worksurfaces onto console with the seam
centered over the mid-support leg.
5. Attach to worksurfaces with (4) 1/4-20 x 15mm JC bolts
Worksurface-to-Worksurface connection:
1. Attach the (2) unit-to-unit brackets to one installed worksurface (use inner holes)
with 1/4-20 x 15mm JC bolts. Do not tighten completely
. Figure 7A
.
2.
Set the second worksurface onto the unit-to-unit brackets, and adjacent assembled wall filler panels.
3.
Align the worksurface mounting holes with the wall filler panel mounting holes.
4. Attach with 1/4-20 x 15mm JC bolts.
Worksurface Assembly
Note:
Mid-support legs are used at the joint connec-
tion of two worksurfaces to provide support for two
or more open spaces (or wall filler panels) wide.
Note:
This is the connection between two worksurfac-
es with open area underneath (no equipment racks).
To provide adequate support, areas under worksur
-
faces generally should not exceed a span of more than
two open spaces (or wall filler panels) wide.
0108630R11 Page 7 of 10
Figure 7A
Underside of
worksurface
Unit-to-unit
brackets
Wall filler
panel
Wall filler
panel
1/4-20 x 15mm JC bolt
(2 per bracket)
Worksurface
Worksurfaces
Mid-support leg
1/4-20 x 15mm JC bolts
(4 required)
Wall
filler
panel
Glides
Figure 6
1/4-20 x
15mm JC bolt
(4 required per
connection)
Wall filler
panel
Wall filler
panel
