0103148R8 Page 6 of 11
Floor anchoring (Toe Kick versions only)
1.
If your Media Director is equipped with a toe kick, and you wish to attach it to the floor, the toe-kick
will need to be detached from the lectern. To detach, open the doors and remove the (4) 1/4-20 x
40mm JC bolts (one on each corner) from inside the lectern.
Figure 4A
. (Save these fasteners).
2. Carefully lift the lectern off the toe kick and set aside. This will require several people.
Figure 4B
.
3.
Determine and locate the toe kick into its final position on the floor and mark the (4) mounting hole
locations on the floor. (The toe kick mounting holes are 1/2” dia.)
4.
Drill suitable holes into the floor and anchor the toe kick with appropriate fasteners.
5. Carefully lift the lecternt back onto the toe kick and align the (4) mounting holes.
6. Re-attach the lectern to the toe kick with the previously removed JC bolts.
7. The access panel can be removed to access wiring below the cart.
Figure 4B
Note: (4) fasteners are required to anchor the
toe kick to the floor. Due to the wide variety
of flooring materials and conditions possible,
anchor fasteners are not provided.
(4) 1/2” [1.27 cm]
Mounting holes for
floor anchors
1/4-20 x 40mm JC bolt
(access from inside lectern)
4 required
Access panel
Toe kick
Tools
Required
4mm Hex
wrench
(included)
Drill
Figure 4A
1/4-20 x 40mm
JC bolts
Lectern
