Quick-release door hinge operation
The front and rear doors can easily be removed for equipment installation.
1. To remove the door, pull down the quick-release lever as shown in
Figure 2A
while lifting out the door.
2. To re-attach the door, pull down the quick-release lever while inserting the door hinge pins into the hinge pin holes.
Figure 2
.
Release the lever when the upper hinge pin is aligned with the upper hinge pin hole-this will secure the door.
Figure 2A
Figure 2
Hinge pin
Lower hinge
pin hole
Quick-release
lever
Hinge pin
Upper hinge
pin hole
Instructor-side door
Door Alignment Procedure:
If the door appears to be misaligned, a slight adjustment can be made to the bottom hinge-side of the door.
Figure 2B
.
1. Using the quick-release lever, remove the door.
2. Set the removed door on a non-abrasive worksurface.
3. Slightly loosen the nylon locknut on the bottom corner of the door with a 3/8” or adjustable wrench and Phillips screwdriver.
4. Reposition the locknut and screw on the bottom of the door as required:
a. Move nut and screw away from the handle-side of the door to raise the handle-side of the door.
b. Move nut and screw toward the handle-side of the door to lower the handle-side of the door.
5. After adjustment, be sure the locknut is tightened securely.
6. Reinstall door and check alignment.
7. Repeat this procedure if necessary.
To lower
handle-side
of door
To raise
handle-side
of door
Figure 2B
Locknut
Bottom of door
0103148R8 Page 3 of 11
