0114246R1 Page 6 of 12
1. Place the top panel face-down onto a non-abrasive surface.
Figure 2C
.
2. Align and attach the corner columns to the top panel using 1/4-20 x 5/8” PHM screws. Do not tighten completely yet.
Figure 2C
side panel
side panel
door stop bracket
(attach w/ two 8-32 x 1/2” PH
thread-cutting screws)
(door will be hinged on the
opposite side as the bracket)
8-32 x 1/2” PH
thread-cutting
screws (2 per side)
corner
column
corner
column
glides
(3 req’d)
floor bracket
(optional)
top panel
(solid shown)
for solid top
panel install:
(3) 1/4-20 x 5/8”
PHMS
B. Assemble pedestal
corner
column
for open top
panel install:
(1) 1/4-20 x 5/8”
PHMS here only
Note:
If you will be attaching the pedestal riser later with the open top panel, install (1) 1/4-20 x 5/8”
PHM screw in the center mounting hole of each corner column. Longer screws will also be used during
the riser assembly on p.8 to secure the riser to the corner columns.
3. Attach the (2) side panels to the corner columns as shown with 8-32 x 1/2” PH thread-cutting screws. (4) screws per panel will be used.
Tighten securely, but do not overtighten these screws.
4. After the side panels and corner columns are installed, tighten all screws.
5. Install a glide into each corner column.
6. Determine which side you’d like the door to be hinged (from left or right). The door is symmetrical and can be hinged from the left or right side.
Attach the door stop bracket to the corner column opposite the determined hinge side with (2) 8-32 x 1/2” PH thread-cutting screws. Tighten screws
securely, but do not overtighten these screws.
7. Optional:
If the unit is to be anchored to the floor, attach a floor bracket to each corner column with a 1/4-20 x 5/8” PHM screw and 1/4-20 locknut.
8. Flip the unit over.
