Phillips
Screwdriver
Glide
wrench
(included)
Tools Required
1. Table assembly - 37109
0114246R1 Page 4 of 12
A. Assemble legs
1. To make a leg assembly, attach a leg bracket (notches facing leg plates
Figure 1B
)
to two legs with (4) 1/4-20 x 5/8” PHM screws.
Figure 1A
. Leave these screws
loose until the legs are attached to the worksurface. This will help align the mount-
ing holes. Each table requires a left and right leg assembly.
2. Attach the front bell glides and casters as shown.
3. Repeat this procedure for each set of legs.
Figure 1A
left
leg assembly
front bell
glides
rear
caster
rear
caster
right
leg assembly
leg
bracket
leg
bracket
Figure 1C
B. Attach legs to worksurface
1. Place the worksurface face-down onto a non-abrasive surface.
2. Attach each leg assembly to the worksurface with (8) 1/4-20 x 5/8”
PHM screws.
Figure 1C
. Note: Bell glides should be on the curved-
side of the worksurface.
3. Tighten all screws securely.
4. Flip table upright.
5. Repeat this assembly procedure on all three tables.
worksurface
1/4-20 x 5/8” PHMS
(8) per leg assembly
left
leg assembly
right
leg assembly
bell
glide
bell
glide
1/4-20 x 5/8” PHMS
(4) per leg assembly
1/4-20 x 5/8” PHMS
(4) per leg assembly
caster
caster
notches facing
leg plates
Figure 1B
leg
leg
leg
plate
leg
leg
leg
plate
Note:
Each table comes with
(4) casters and (4) glides. The
table can be assembled with all
4 casters for frequent mobility,
4 glides
for fixed locating, or
2 casters / 2 glides for oc-
casional mobility.
Figure 1A
below shows the 2 casters / 2
glide assembly option.
