0112776R4 Page 2 of 9
1. Attach legs to worksurface
A. Set the assembled worksurface face-down onto a
flat non-abrasive surface like a carpeted floor close to the table’s final location.
B. Set the legs onto the bottom of the worksurface as shown with the insert panels facing toward the center.
Figure 1
. Note the rear leg
(with the grommet hole) will mount on the flat edge of the worksurface.
C. Align the mounting holes and attach the legs with 1/4-20 x 1-3/4” PHM screws. Do not tighten these screws completely yet.
D. On the rear leg, install (2) 1/4-20 JC nuts, and (2) 1/4-20 x 45mm JC bolts through the worksurface. (This will require the worksurface
be lifted slightly off the floor and blocked up temporarily to install). It’s important these fasteners be installed for support before the unit is
tipped upright.
E. Install the glides onto the bottom of the legs and tighten securely.
Figure 1
assembled
worksurface
front leg
(no grommet)
rear leg
(with grommet hole)
1/4-20 x 1-3/4”
PHM screws
(4 on rear leg)
glide
(2 per leg)
1/4-20 x 1-3/4”
PHM screws
(6 on front leg)
1/4-20 x 45mm
JC bolts
(2 on rear leg)
1/4-20 JC nut
(2 on rear leg)
