background image

0118408R12 Page 2 of 20

DANGER - General Safety:

1.  SAVE THESE INSTRUCTIONS 

2.  Do not allow children to move.

3.  Do not leave unit unattended in areas where children have access.

4.  Keep unit locked when unattended.

5.  Proceed slowly and carefully when moving.

6.  Close supervision is necessary when this furnishing is used by, or near children, 

invalids, or disabled persons.

7.  For indoor use only.  Do not install or store where it will be exposed to moisture.

8.  Do not block the ventilation openings.

9.  Avoid uneven loading of the equipment into the unit.  Uneven weight distribution 

could cause unit to tip when mobile.

10.  Do not allow anyone to sit, stand, or climb on the unit.

11.  When loading, place heavier objects near the bottom of the unit to avoid tipping.

12.  To clean dirty surfaces, use a damp, soft-cloth, or sponge, with mild soap or 

detergent solution.  Do not use harsh solvents or abrasives.

13.  Never drop or insert any object into any opening.

14.  This unit is intended for institutional, commercial use only.

15.  Use this furnishing only for its intended use as described in these instructions.  Do 

not use attachments not recommended by the manufacturer.

16.  This unit does not have any user-serviceable parts.  If servicing is necessary, please 

contact Spectrum Industries for assistance.

DANGER - To reduce the risk of electric shock:

1.  This furnishing is only to be used with the power supply unit provided.

2.  Always unplug this furnishing from the electrical outlet before cleaning.

3.  For added safety, plug the cart into a grounded outlet controlled by a GFI 

(Ground 

Fault Interrupter) circuit breaker.

4.  Keep the power switch in the OFF position before plugging or unplugging from the wall outlet.

5.  Turn devices OFF before plugging them in.

6.  This furnishing has a polarized plug (one blade wider than the other).  This plug will 

fi t into a polarized outlet only one way.  If the plug does not fi t fully into the outlet, 

reverse the plug.  If it still does not fi t, contact a qualifi ed electrician to install the 

correct outlet.  Do not alter the plug in any way

7.  Do not plug the power cord into an extension cord.

8.  Inspect the power cord for damage before each use. Do not operate if cord or plug 

has been damaged, or has come into contact with water.

9.  To disconnect power, turn all controls to the OFF position, then remove plug from 

outlet.  Do not pull on cord.

10.  Disconnect power before adding or removing components.

11.  Do not run power cords across hallways or classrooms.  Do not step on, drive over, 

drag, or place objects on cord.  Keep cord away from heated surfaces.

12.  If servicing is necessary, please contact Spectrum for assistance.

13.  Damaged electrical components can create signifi cant hazards to users and is not 

covered by the warranty.  Repairs should always be performed by a qualifi ed electrician.

14.  Electrical devices are not toys.  Children are often unaware of the hazards 

associated with electrical devices.  This cart must always be used by adults or with 

adult supervision.

WARNING

To reduce the risk of burns, fi re, electric shock, or injury to persons, unplug from 

outlet(s) before installing or removing components

WARNING

A remote control or toys placed on the furnishing may encourage a child to climb on the 

furnishing and as a result the furnishing may tip over onto the child. Serious injury or death 

could occur when children climb on audio and / or video equipment furniture.

WARNING

Relocating audio and/or video equipment to furniture not specifi cally designed to support 

audio and/or video equipment may result in serious injury or death due to the furnishing 

collapsing or over turning onto a child.

CAUTION

Risk of Electric Shock.  This unit may have multiple power cords.  Unplug all power 

cords before moving or servicing this furnishing.

Important Safety and Care Instructions

Note:  This unit is not designed for use with cord 

reels or surface-mount cord reel accessories.

CAUTION

•  Always unplug lectern before working under the worksurface or 

inside rack cabinet.

•  Do not place anything under worksurface when operating lift.

•  Use caution when raising or lowering the worksurface!

•  Be sure lectern movement does not interfere with objects or people

Summary of Contents for Freedom One eLift Lectern 55357





















Reviews: