052519R6 Page 2 of 5
Figure 2.1
The side of the leg
with the threaded
hole should be on
the flip-top side
Flip-top
Worksurface
1/4-20 x 5/8”
PHMS
(2 per leg)
Left leg
One-piece upper leg
Figure 2.2
Worksurface
#14 x 1-3/4”
PHMS
(2 per leg)
Welded tube upper leg
The side of the leg
with the threaded
hole should be on
the flip-top side
Left leg
1. Place the worksurface face-down onto a non-abrasive surface.
2. Align the legs with the mounting holes, and install (2) 1/4-20 x
5/8” PHM screws into each leg but do not tighten completely yet.
Figure 2.1
.
1. Place the worksurface face-down onto a non-abrasive surface.
2. Align the legs with the mounting holes, and install (2) 1/4-20 x 1-3/4”
PHM screws into each leg but do not tighten completely yet.
Figure 2.2
.
One-piece
upper legs
Welded tube
upper legs
NEW!
Note: There are two types of Evolution legs-the newer style one-piece upper leg, and the original welded tube upper leg.
Fasteners are provided for both types (included in leg box). Be sure to use the screws shown below with the corresponding leg.
‘U’ Channel
Square
tube
Flip-top
Attach legs to worksurface
2
(4) 041289
1/4-20 x 1-3/4” PHMS
(4) 026064
1/4-20 x 5/8” PHMS
