Spectrum Illumination, Monster Brain Controller Manual
6
Rev. Date: 2013-11-27
4)
Wire all of the power and output cables to the drivers as diagrammed on the
driver spec sheet(s) for the model used.
5)
Wire the Monster Brain with +24 Volts DC to a maximum of +28 Volts DC on Pin
#1 of the
RED CONNECTOR.
Connect the ground of the power supply to Pin
#2 of the
RED CONNECTOR.
(
Note
: ensure grounds of all drivers and the
Monster Brain are a common ground, if all devices are not being run with the
same power supply.)
6)
Determine the number of analog bus outputs that are needed. Analog drivers
are used to vary the output of the light. If all of the lights need to be the same
intensity then only one (1) analog output channel will be needed. However, up
to three different intensities can strobe (at the same time) on one (1) strobe line
with
the setting “1 strobe, 3 analog”.
M
B
C
O
N
T
R
O
L
L
D
M
7
0
0
L
D
M
7
0
0
L
D
M
3
5
0
/
2
L
D
M
3
5
0
/
3
+24 V
GND
