MOUNTING LOCATION
MOUNTING LOCATION
Check the suitability of your preferred amplifi er location carefully, before you start installation attempts. Always try
Check the suitability of your preferred amplifi er location carefully, before you start installation attempts. Always try
to choose a place where you can be sure nothing gets damaged behind or below the panel, by drilling the holes for
to choose a place where you can be sure nothing gets damaged behind or below the panel, by drilling the holes for
the amplifi er mounting screws. Be aware that after the amp has been mounted, there should be a clearance of at least
the amplifi er mounting screws. Be aware that after the amp has been mounted, there should be a clearance of at least
5cm on all sides, for best cooling and to access the side panel for the adjustments of the electronic crossover.
5cm on all sides, for best cooling and to access the side panel for the adjustments of the electronic crossover.
Attention! For your own safety, disconnect the negative battery terminal (GND) or remove the main fuse of the
Attention! For your own safety, disconnect the negative battery terminal (GND) or remove the main fuse of the
12V power cable, before you start any wiring work!
12V power cable, before you start any wiring work!
Once the location where the amplifi er will be mounted is found, use the unit as a template and mark the mounting
Once the location where the amplifi er will be mounted is found, use the unit as a template and mark the mounting
holes with pencil or felt-tip marker. Pilot-drill these holes, using a 2,5mm or 3mm drill bit on your power drill. Insert
holes with pencil or felt-tip marker. Pilot-drill these holes, using a 2,5mm or 3mm drill bit on your power drill. Insert
the supplied rubber washers into the mounting holes of the amp. The amplifi er must be mounted totally isolated from
the supplied rubber washers into the mounting holes of the amp. The amplifi er must be mounted totally isolated from
the vehicle’s chassis ground, or metal parts. Now bolt the unit in place with the supplied self tapping screws.
the vehicle’s chassis ground, or metal parts. Now bolt the unit in place with the supplied self tapping screws.
A
MPLIFIER
M
OUNTING
37
Spectron_Manual_SP-R2200-R4100-1500.indd 37
Spectron_Manual_SP-R2200-R4100-1500.indd 37
9.10.2007 11:01:29 Uhr
9.10.2007 11:01:29 Uhr
