SpectraPure
®
Inc
.
Fax 480.894.6109 Fax us toll-free 1.877.527.7873
E-mail: [email protected] Visit us on the web www.spectrapure.com
7
SpectraPure
®
SYSTEM INSTALLATION & INITIALIZATION:
1. Most of the components of this system are plastic and are subject to damage by
ultraviolet light from the sun and other sources such as metal halide lighting.
2. Avoid installing this unit in an area where it may be subjected to bright light
or direct sunlight, as algae is more likely to thrive inside the clear filter housings
when exposed to bright light. The unit must be kept out of areas that are
subject to freezing temperatures.
3. High temperatures greater than 113° F (45° C) must be avoided. If the unit is
used outside, avoid putting the system in direct sunlight or connecting it to a
garden hose that may be exposed to sunlight.
4. Attach the black tap water tubing to the left side of the Sediment Filter Housing
(See “IN Port” on page 4).
5. Attach the yellow drain line to the union connector at the rear of the system. This
connector already has a red tube attached to it.
6. Attach the blue product line to the front port (after the “tee”) of the right-hand
DI housing. (See image below)
7. Attach the black tubing and elbow to the membrane housing cap.
8. Attach the garden hose adapter
(connected to the black tubing)
to your
cold water source. Never run hot water (greater than 113° F/45° C) through
the system.
9. Remove the DI filter cartridge from the right-hand filter housing. Reconnect
the housing to its threaded cap. Hand tighten.
10. An optional ball valve can be located at a convenient place on the black tap
water line. Cut the black tubing in two and reconnect the two cut ends with
the ball valve, if desired.
(continued on next page)
