SpectraLink Corporation
Setup and Administration–NetLink Wireless Telephone
(With SpectraLink Radio Protocol and NetLink Telephony Gateway)
8.5 Wireless Telephone Status Messages
Wireless Telephone status messages provide information about the NetLink Wireless
Telephone's communication with the access point and host telephone system. The
following table summarizes the status messages, in alphabetical order.
Message Description
Action
3 chirps
Wireless Telephone is not able to
communicate with the best AP,
probably because that AP has no
bandwidth available.
None. This is only a warning, the
call will handoff to the best AP
once it becomes available.
BATT, Low Battery,
and beep
Low battery
In call: BATT displays when the
user is on the Wireless Telephone
and the battery charge is low.
User has two minutes to complete
call. The battery can be changed
while the call is still in progress. Do
not press End. Quickly remove the
discharged battery and replace
with a charged battery, power on
the Wireless Telephone, and press
Start to resume the call in
progress.
Not in call: Low Battery and Beep
indicate low battery charge when
user is not on the wireless
telephone. The Wireless
Telephone will not work until
battery is replaced.
Checking Code
Wireless Telephone is contacting the
Download Master to determine if it
has a newer version of software that
should be downloaded.
None, this message should only
last for approximately one second.
If message remains displayed,
power off and contact customer
support for a replacement phone.
DHCP Error (1-4)
DHCP Error 1
The Wireless Telephone cannot
locate a DHCP server. It will try
every 4 seconds until a server is
located.
DHCP Error 2
The Wireless Telephone has not
received a response from the
server for a request to an IP
address. It will retry until a server is
found.
DHCP Error 3
The server refuses to lease the
Wireless Telephone an IP address.
It will keep trying.
PN: 72006509B.doc
Page 26
