Spektra S.r.l
Spektra S.r.l
Spektra S.r.l
Spektra S.r.l....
-
via Pavia 29, 21052 Busto Arsizio (VA) – ITAL
ITAL
ITAL
ITALY
Y
Y
Y ----
www.spektra
www.spektra
www.spektra
www.spektra----srl.it
srl.it
srl.it
srl.it
11
GENERAL NOTES ON THE OPERATION
GENERAL NOTES ON THE OPERATION
GENERAL NOTES ON THE OPERATION
GENERAL NOTES ON THE OPERATION
The correctly programmed PIXEL GPRS/SMS tracker devices interact with our PIXEL
PIXEL
PIXEL
PIXEL MULTIVEICOLO
MULTIVEICOLO
MULTIVEICOLO
MULTIVEICOLO
software installed on a PC.
Note that the complete software package and updates can be found on our website:
http://WWW.SPEKTRA
http://WWW.SPEKTRA
http://WWW.SPEKTRA
http://WWW.SPEKTRA----SRL.IT
SRL.IT
SRL.IT
SRL.IT
We remember also that the device PIXEL GPRS / SMS with the command immediate point (##PI) sends
an SMS to mobile phones and smartphone, which are connected to the Internet, allowing the display
of the location of the device maps directly to GOOGLE Maps.
These special encrypted SMS allow the localisation of the PIXEL GPRS/SMS tracker device even
without the use of a PC and a modem.
To view the firmware version installed on the device, use the ‘##D1’ diagnosis command and wait for
the response from the tracker device.
The tracker device will reply with a message whose first line could be:
“PIXEL-GPRS V1.6 – D1” indicating version 1.6 of the firmware
In the diagnostics section and especially following a ##D6 request:
-
the SING:xx parameter indicates the field intensity of the GSM signal currently detected by the
PIXEL GPRS/SMS.
xx = 05 insufficient GSM signal intensity.
xx = 30 optimum GSM signal intensity.
-
the MAIN CELL:xxxx…. parameter indicates the data of the main GSM cell to which the tracker
device is connected. This hexadecimal numerical value is displayed as received by the cell phone.
In the diagnostics section and especially following a ##D7 request:
-
The BATTERY:xxx parameter indicates the input voltage measured by the tracker device. This
value is only valid and reliable when it is powered using the internal stabiliser as described below.
If the red LED on the tracker device flashes, it is possible to detect the number of satellites
connected to the tracker device . Each rapid flash corresponds to a satellite. Note that the flash will
be slow and long lasting if insufficient satellites have been detected to obtain a reliable localisation.
The flashing sequence described above occurs whenever the time range set in the parameter
##TM00005 expires (default is 5 seconds).
NOTE:
NOTE:
NOTE:
NOTE:
The Spektra S.r.l. thanks you again for your confidence over the years and ensures a constant
commitment to the development and optimization of the product. Therefore, please check back
periodically for updates and documentation releases new FW and SW in a perspective of continuous
growth that has always distinguished. Our staff is always available for any questions about product
features and for any and / or requests for implementations. Any omissions, errors and / or changes are
therefore not attributable to carelessness in the preparation of this document, but must be considered
in view of the above-mentioned development.
