SPECTRA CR700 DUAL DETECTORS
2
General Setup & Usage
PROCEDURE
●
Fix one of the CR700’s securely onto its magnet mount, then switch ON.
●
Allow the detector to calibrate (CAL). This only takes a few seconds.
●
Best practice is NOT to calibrate detector with the laser running.
This is now the “Machine
CR700”.
●
Next, switch ON the second Cab Repeater CR700. Let it calibrate. Again, this only takes a few
seconds.
●
The display will show
RMT.D
and a fl ashing “OK”. This stands for “remote detector”
●
Quickly press the Enter button on the CR700. (It is the bottom left-hand button).
●
“OK” will stop fl ashing.
●
Within 5 secs the CR700’s display will show
RMT.D
at the top.
●
THE SYSTEM IS NOW READY TO USE.
●
To switch OFF
, hold ON/OFF button for 3 sec. The detectors can be switched off in any
order.
VERY IMPORTANT
●
Always be careful to switch the Machine CR700 on fi rst & the Cab Repeater CR700 second,
otherwise the Machine CR700 changes to be the cab repeater, which is incorrect.
Below are some extra system refi nements, worth consideration…….
Machine CR700
●
To save battery life, the sounder needs to be OFF and the LED’s set to LOW. (You are not
seeing nor hearing it, when in operation).
●
Set the sensitivity (top right-hand button) to suit. The range is between 0.5mm for staff
use, up to 25mm on the machine. If its set too sensitive, it makes it diffi cult to use on your
machine.
Cab Repeater CR700
●
Mount the Cab Repeater securely, without obstructing the Operator’s view.
●
Set sounder to low volume using the bottom right-hand button.
●
Your choice of course. It can be set louder or Off , if required.
●
Sensitivity: Start with it set to 10mm.
●
This will automatically change the sensitivity of the Machine CR700 too.
●
There is the option of a 25mm setting, if this is more appropriate.
This data sheet gives helpful advice on the CR700/CR700 dual combination for machine use.
Note: Prior to dispatch, both CR700’s will be pre-paired via radio link.
