background image

2

Front Panel LED Board Replacement 

90950014

Copyright

Copyright © 2009 Spectra Logic Corporation. All rights reserved. This item and the 
information contained herein are the property of Spectra Logic Corporation. 

Notices

Except as expressly stated herein, Spectra Logic Corporation makes its products and 
associated documentation on an “AS IS” BASIS, WITHOUT WARRANTY OF ANY 
KIND, EITHER EXPRESSED OR IMPLIED, INCLUDING BUT NOT LIMITED TO 
THE IMPLIED WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A 
PARTICULAR PURPOSE, BOTH OF WHICH ARE EXPRESSLY DISCLAIMED. In no 
event shall Spectra Logic be liable for any loss of profits, loss of business, loss of use or 
data, interruption of business, or for indirect, special, incidental or consequential 
damages of any kind, even if Spectra Logic has been advised of the possibility of such 
damages arising from any defect or error.

Information furnished in this manual is believed to be accurate and reliable. However, no 
responsibility is assumed by Spectra Logic for its use. Due to continuing research and 
development, Spectra Logic may revise this publication from time to time without notice, 
and reserves the right to change any product specification at any time without notice.

Part Number

90950014 Revision A

Revision

History

Contacting

Spectra Logic

Revision

Date

Description

A

July 2009

Initial release

To obtain general information

Spectra Logic Web Site: 

www.spectralogic.com

 

United States Headquarters

European Office

Spectra Logic Corporation
1700 North 55th Street
Boulder, CO 80301
USA

Phone:

1.800.833.1132 or 1.303.449.6400

International:

1.303.449.6400

Fax:

1.303.939.8844

Spectra Logic Europe Ltd.
Magdalen Centre
Robert Robinson Avenue
Oxford Science Park
OXFORD
OX4 4GA
United Kingdom

Phone:

44 (0) 870.112.2150

Fax:

44 (0) 870.112.2175

SpectraGuard Support

Web Site:

www.spectralogic.com/support

Knowledge Base:

www.spectralogic.com/knowledgebase

United States and Canada

Phone:

Toll free US and Canada:

1.800.227.4637

International:

1.303.449.0160

Email:

[email protected]

Europe, Middle East, Africa

Phone:

44 (0) 870.112.2185

Email:

[email protected]

Deutsch sprechende Kunden

Phone:

49 (0) 6028.9796.507

Email:

[email protected]

Mexico, Central and South America, Asia, Australia, and New Zealand

Phone:

 1.303.449.0160

Email:

 

[email protected]

To obtain library documentation

Spectra Logic Web Site: 

www.spectralogic.com/documents

 

Summary of Contents for T120 LIBRARY









Reviews: