Technical Manual
MX800 Transceiver T19 Option
4.
Refit mother board to chassis. Don’t refit the four screws indicated below on the motherboard
and fit Qty 4 3x20mm standoff posts in the positions where the screws where removed.
Motherboard
3x5mm machine
screws to be removed
5.
Punch out the RJ45 square on the rear of radio.
6.
Install RJ45 daughter board in the rear of chassis, locate the RJ45 socket into punch hole.
Locate mount holes over chassis stand off. Secure with 3x 3mm screws.
7.
Remove the Link jumpers off Mother Board connector SKK.
8.
Install the CABLE IDC SKT - IDC SKT 16W 125mm cable Assy between connector SKK
on the Motherboard and SKK on the Option board.
9.
Install the CABLE IDC SKT-IDC SKT 16WAY 210mm cable Assy. between connector
AUX3 (SKX) on the Motherboard and SKX on the Option board. This cable will be under
option PCB when mounted.
10. Install the Option Printed Circuit Board onto the 4 standoffs with the 16way connector closest
to DIP2 on the Motherboard. Secure with the qty4 3x5mm machine screws previously
removed.
11.
Install the CABLE IDC SKT-IDC SKT 16WAY 170mm cable Assy. between connector
SKH on the Motherboard and SKH on the Option board.
12.
Install the CABLE IDC SKT-IDC SKT 10WAY 150mm cable Assy. between connector
SKV on the Motherboard and SKV on the Option board.
13.
Remove and replace CN1 with CABLE IDC DB9M-IDC SKT 10W 195mm cable Assy.
Connect to SKU on the Option board.
14.
Remove and replace CN4 with CABLE IDC DB15F-IDC SKT 16W 210mm cable Assy.
Connect to SKH/B on the Option board.
15.
Check that the option board jumpers are in the correct positions for application.
16.
See the appropriate application section for Setup procedure.
11
© SPECTRA ENGINEERING 2010 Revision 1.0.4