4
Figure 2-2
Note:
Press the “Reset” button shown in Figure 2-2 for 10 seconds when the device is powered on
if the device needs to be restored to factory default setting.
1.
Find the micro SD card slot and open slot according to the direction shown in Figure 2-3.
Figure 2-3
2.
Adjust the direction of the micro SD card and install it into the slot.
3.
Close the card slot and lock it firmly.
Step 2
1.
Put installation template on the designated surface where you will install the device (wall or
ceiling).
2.
Drill holes according to position of the holes on the installation template and then insert the
expansion bolts in the holes. Secure these three bolts firmly.
3.
Adjust the device installation pedestal to the proper position and then pull cable through the
exit hole on Installation surface. Make direction of TOP sign same as it is on the installation
template. Line up the three screw holes in the device pedestal to the three plastic expansion
bolt holes in the installation position. Put the three self-tapping screws in the three plastic
expansion bolts firmly. Fix dome body on installation
surface.
