5
Note:
If user pulls out cable from top of installation surface, you must dig an exit hole on
installation surface according to the installation template.
If user pulls out cable from side of cable channel, it must go through the U-shape channel on
dome pedestal, and take out cable from the side exit hole on pedestal.
Step 3
Adjust device monitoring direction, which is shown in Figure 2-4.
Figure 2-4
Hold both sides of the rotation bracket bottom with hands, rotate horizontally along the axis, and
adjust lens horizontal direction to designated position. Hold the LED decoration cover with hand,
rotate along the vertical direction, adjust the lens vertical direction to designated position; it is
okay to loosen the fix screws on both sides of the bracket first if it is too tight to adjust (just make
it loose, do not take it out), then adjust the lens, tighten the fix screws after adjustment. Hold the
LED decoration cover with hands, rotate horizontally along the axis, and adjust the lens image to
designated position. Range of lens: vertical (0°
～
+64°), horizontal (0°
～
+355°), image rotation
direction (0°
～
+355°).
Note:
The motorized vari-focal series are equipped with motorized vari-focal lens by default, which
needs no manual adjustment.
Step 4
Take up the dome enclosure, put it back on the camera properly regarding to screw and hole, and
fasten the three inner hex screws with wrench.
Note:
Make sure the dome enclosure is secured tightly.
Step 5
Waterproof connector installation for network port; see Figure 2-5 for more details.
