7. Power Inlet
The cable from the power module connects to this 10 pin rectangular
connector. This connector and its respective plug are keyed so they will
only fit in one direction. For power module installation instructions,
refer to the Installation Section in this manual.
The connector illustration is shown in Figure 4. 16VAC from the external
power module is connected between pin 7 and pin 9.
8. Gain Select
Each channel has a gain select jumper directly below the fader on the bottom panel (See Figure 5).
The factory default setting is for 0dB of gain. 10dB of gain can be added to the channel by moving
the position of the jumper. With the gain select set for 10dB and the slide fader set at the “10” mark
this will give the channel a total of 20dB of gain.
Chapter 3
Operation Section
12
0dB Setting
10dB Setting
(Factory Default)
Figure 5.
Gain Select
8
BALANCED INPUTS 1-8
BALANCED INPUTS 9-10
BALANCED OUTPUTS 1-8
BALANCED OUTPUTS 9-10
OUTPUTS
INPUTS
9
10
9
10
7
10
9
8
7
6
5
4
3
2
1
Figure 4
16VAC
