Power Module Installation
The
One Fader
is shipped with an external 16 VAC power module. The power module has a 6' (1.8M)
cable and is fitted with a special 4 pin connector for mating to the "Power Input” on the rear panel. All
AC rectification, filtering, and DC regulation is performed within the chassis of the One Fader.
The PS4-F power module is available in two versions: a North American version and European version.
The North American version (PS4-F-NA) is designed to operate with 100 or 120 VAC power and the
European version (PS4-F-EU) is designed to operate with 220, 230, or 240 VAC power.
Use only the PS4-F external power module that is supplied with your One Fader. Using any other
power module or power source will most definitely damage your product.
To connect the power module to the
One Fader
, fit the 4 pin rectangular connector to the chassis mount
receptacle at the rear. The respective connectors are keyed so the plug and the receptacle can fit in only
one direction.
Before connecting the 4 pin rectangular plug to the One Fader, make certain the power
module is not connected to an AC receptacle.
The PS4-F power module has an internal “one shot” thermal fuse. Fuse replacement is not possible with
this module. If it has been determined that the power module has failed, contact Speck Electronics for a
factory replacement at +760-723-4281.
The power module is a "Class 2 transformer" device and can only be used indoors. Your product
and power module should never be exposed to rain or moisture.
Chapter 2
Installation Section
4
PS4-F-EU
PS4-F-NA