18
Final Assembly - continued
11. Mount the volume control knob (part #21.1) and air regulator knob (part #111) by means of a rubber mallet and a
protective cloth.
(See Figure 23)
21/1
111
46
38/2 38/1
37
37
110
112
Figure 22
Installation of Light Cover
Figure 23
Installation of Knobs
Electrical Installation
WARNING:
The wiring of the pool motor and control box should be done by a licensed electrician in accordance with all local,
state, and federal codes. Be certain that the motor frame and control box are grounded. Motor name plate has voltage, phase,
amp draw, and other motor information as well as wiring connection instructions.
This section concerns the electric motor, control box, and metal parts of the BaduJet Imperial.
CAUTION: Before installing the Speck Pump, read the entire pump owner’s manual found in the pump box.
Consult local codes for minimum distance between pump and pool. Locate pump as close to the pool as practical.
CAUTION: There is 30 ft. of air tubing for the air buttons as well as 30 ft. of cable for the LED light included with the BaduJet
Imperial. The control box should be installed within this distance of the jet housing. If a longer distance is required, please
contact the factory regarding the use of smaller diameter air tubing.
BONDING: As required by the National Electrical Code, the electric pump motor, stainless steel handles, and stainless steel
cover must be electrically bonded to the pool structure (reinforced bars, etc.) by a solid copper conductor not smaller than No.
8 AWG. Bonding lugs are provided on the electric pump motor, stainless steel handles, and stainless steel cover. A 3ft length
of 8 AWG insulated solid wire (10” of insulation stripped back) is provided with the swim jet. Refer to the
Bonding Instructions
section on pages 16 for installation.
CAUTION:
The strain relief MUST be completely tight around the bonding wire. The BaduJet Imperial WILL LEAK if this
strain relief is left loose!
