8
Chapter 2
Connections
How to connect the speaker cords
The connection terminals are red for positive (+) and black
for negative (–).
1
Twist the wire.
2
Loosen the speaker terminal, and insert the speaker cord.
3
Once the speaker cord is inserted, tighten and secure the
speaker terminal.
The connection terminals on this product are also
compatible with Y lug terminals and banana plugs.
Caution
•
Use speakers with nominal impedance of 4 Ω to 16 Ω.
•
Connect accurately the + and
–
terminals between the speakers
and this product.
•
Do not allow unshielded center wire from the terminals to stick
out and make contact with each other. If the center wires touch
the device may break.
•
Use sufficient current capacity speaker cord and be sure to make
connections that are not loose and do not short. Using low current
capacity connecting cords or making imperfect connections may
affect playback audio and can cause overheating or short circuits.
•
High voltage is output from the speaker terminals. To avoid the
danger of electrical shock, be sure to unplug the power cord before
making speaker connections.
How to connect XLR cables
Connect the left and right XLR input terminals of this
product to the respective left and right balanced output
terminals of the product to be connected.
Match the orientation of the XLR plug to this product’s XLR
input terminal, and insert until a click is heard.
LINE 2
When disconnecting an XLR plug, press the latch lever
(the part with “PUSH” inscribed on it) while pulling the
cable. Use caution, as forceful disconnection may damage
the unit.
LINE 2
Note
•
The pin positioning of the XLR input terminal of this product is
depicted below. Confirm that the product to be connected is
compatible with the pin positioning of this product. For further
details, consult the operation manual included with the product
to be connected.
1
2
3
1: Ground
2: Hot
3: Cold
Y lug terminals
Banana plugs
3
2
1
10 mm
