Spearhead
Q15s, Q18s & Q21s
15
15
15
15
•
When flails are showing severe wear, damage or cracking, they must be
replaced immediately. Never attempt to weld the flails, as this will make them
very brittle, thus extremely dangerous. Do not take risks with the cutting flails,
if in doubt replace.
•
When replacing flails always replace bolts and nuts for new.
•
Regularly check that all rotor-bearing bolts are tight.
•
It is imperative the grub screws are checked on the taper locks (once bedded
in locative glue may prove useful).
Greasing
Greasing
Greasing
Greasing
Daily grease all points shown below.
Fig. 6
Grease point for rotor, cross shaft and rear roller bearings.
Warning
Grease rotor bearing and rear roller at least every 8 hours and especially
after washing.
Fig 6
Fig 7
Fig. 7
Dismantle and clean PTO sliding surfaces and re-grease universal joints.
