8999151EN: v1 11/03/2021
86
Original instructions (ENGLISH)
Website: www.spearheadmachinery.com
5.8
Machine Inspection Record
MACHINE INSPECTION
RECORD
(For Multicut 300)
Pre-delivery inspection:
Select
Installation inspection:
Select
Daily pre-work inspection:
Select
Model:
Serial No:
Inspector name (print):
Inspection date:
Company/Position:
Inspector signature:
Visual Checks
Comments
OK
Check that an operator’s instruction manual in the correct
language for the working territory is in the machine document
holder.
Check that the
operator’s instruction manual is filled in and serial
number is present and matches the serial number of the machine.
Inspect main fabrications for damage
– decks, wheel arms,
headstock.
Inspect the headstock to ensure that it can move freely when in
work
Inspect the headstock wire rope ensuring that there is sufficient
slack in order to allow the headstock to float in work
Inspect the headstock wire rope ensuring that the rope is not
frayed. If in doubt; replace
Inspect the wheel arms to ensure they’re matched in their
positioning set-up to offer safe carrying of the machine and level
cutting
Inspect to see all pins are in position and secured with
accompanying linch pin
Inspect to see all warning decals are present, legible and clean
Inspect PTO shaft and cone guards for integrity and condition
Inspect to see all protection chains are present
Inspect to see all fixed guarding protection is present
Inspect the rubber drive couplings for damage/perished material. If
in doubt; replace (if fitted)
Inspect the blade carriers to ensure that they are timing 90° out of
sync with each other
Inspect the underside of the gearbox and for damage and
ingressed debris
Inspect blade condition against the operator’s manual guidance
Inspect that the correct blades are fitted for the given rotor
direction
against the operator’s manual
Inspect blade carrier anti-scalp dish condition against the
operator’s manual guidance (if fitted)
Mechanical Checks
Comments
OK
Ensure the oil gearbox quantity is to the required plug on each
gearbox. Consult the maintenance schedule to see whether an oil
change is scheduled
Ensure the gearbox breather are present and free from dirt
Check the gearbox mounting fasteners are tight to the correct
torque setting given in the
operator’s instruction manual
Randomly test for loose nuts and bolts. Tighten to manual settings
Check the tightness of fasteners in rubber driveline couplings (if
fitted)
Grease all grease points in accordance with the operator’s manual
