20
AFTER SALES SUPPORT
0345 605 2067
MAINTENANCE
•
Unscrew the hex bolt (b) and the self-locking nut (a) on
the tine wheel pair (d).
•
Slide the tine-wheel pair off the driveshaft (c).
•
Clean the driveshaft with biological oil.
•
Slide the new blades onto the driveshaft with the holes
on the axles aligned to the holes on the driveshaft (c).
•
Slide the hex bolt (b) through the hole and tighten on the
self-locking nut(a).
Cleaning the device
IMPORTANT!
■
Wear protective gloves when cleaning or maintaining the machine.
■
Do not use cleaning fluids or solvents or spray the machine down with
water(especially water under pressure) when cleaning the machine.
NOTE: After each use, follow these steps to properly clean the unit:
•
Remove soil, dirt, and foliage stuck in the tines, drive shaft, tool
surface, and vents with a brush or dry cloth.
•
Spray or rub biodegradable oil onto the tines.
•
Clean soiled grips with a damp cloth. Always inspect the machine
for damaged and worn parts after each use. Check that safety
features (i.e. labels, guards, etc.) are in place. Check that nuts,
bolts, and screws are tight.
WARNING!
Unexpected tine movement may
cause personal injury. Before servicing, repairing,
or inspecting the unit, turn the motor OFF and
disconnect the power. Wait for the tines to
completely stop rotating before conducting
inspection, cleaning, or maintenance. Before and
after each use, check the product and accessories
(or attachments) for wear and damage. When
necessary, only use identical replacement parts
that are approved by the manufacturer.
WARNING!
Contact with hot components (e.g.
motor housing, gear box, etc.) on the machine may
cause burns. Allow the machine to cool off before
handling.
a
b
c
b a
d
