32
33
AFTER SALES SUPPORT
0345 605 2067
AFTER SALES SUPPORT
0345 605 2067
MAINTENANCE
Preventative maintenance
Bar/chain maintenance
1. Keep the air intake clean and air vents free of debris to avoid overheating the motor.
2. Clean with a damp sponge and mild soap. Do not squirt with a water hose or douse with
water or other liquids.
3. Inspect the saws chain for proper tension before each use and frequently during cutting.
4. Clean the guide bar and bar pad to ensure free path for oil.
5. Turn the bar over after each use to achieve even wear.
Proper maintenance of the rail, as explained here, is essential to keep your saw in good working
order.
SPROCKET TIP LUBRICATION:
(For unite supplied with sprocket tip guide bars only)
CAUTION:
Place switch in OFF position and remove the battery pack before the
appliance is serviced, cleaned, or maintenance is performed.
WARNING:
Before servicing the saw, make sure that the battery pack is
removed.
WARNING:
Failure to lubricate the reversing star will result in poor performance
and jamming, and will void the warranty.
NOTE:
No motor lubrication is necessary. The motor is equipped with lifetime
lubricated bearings.
NOTE:
If the chainsaw do not operate, turn switch to OFF position and remove
the battery pack first. Do not attempt to repair it yourself.
MAINTENANCE
CAUTION: Failure to lubricate the guide bar sprocket tip as
explained below will result in poor performance and seizure,
voiding the manufacturer’s warranty.
Lubrication of the sprocket tip is recommended after each
saw use. Always thoroughly clean the guide bar sprocket tip
before lubrication.
TO LUBRICATE SPROCKET TIP:
1. Remove the battery pack from the chain saw.
2. Clean the guide bar sprocket tip.
3. Using disposable Lube gunp insert the needle nose into
the lubrication hole and inject grease until it appears at
the outside edge of the sprocket tip.
4. Turn the chain by hand. Repeat this procedure until the
entire deflection star is greased.
WARNING:
Wear heavy duty work gloves when
performing this application to reduce risk of
personal Injury.
NOTE:
It Is not necessary to remove the chain
saw to lubricate the guide bar sprocket tip.
Lubrication can be done on the Job.
