ASSEMBLE
PREPARE
OPERATE
Hold the trimmer head just
above the ground at an angle
of approximately 30°
DO NOT cut long grass in
one cut, as this will damage
your grass trimmer,
and make your warranty invalid.
When cutting longer /high grass,
please make sure that
you cut this down in 2 to 3 stages.
1
2
3
4
7
8
10
5
9
Align the guard (6) to the trimmer
head and place it over it.
Secure the guard with three the
screws which are pre-assembled
on motor housing.
Fix the lower shaft into the upper
shaft.
i. Loosen the bolt with a screw
driver from the front handle.
ii. Align the front handle to the
support and place it onto it.
iii. Insert the bolt from the right
through the opening.
And tighten the bolt with a screw
driver.
i. While the line spool is running at
full speed, tap its underside
briefly against the ground.
ii. If the spool lines are still not
sufficiently extended, tap the
underside against the ground
again.
iii. If the line has already become
too short, it will no longer be
extended by pressing the
underside against the ground. You
must pull it out from the line spool
by hand.
6
6
Connect the extension socket to
the pig tail plug.
30
o
Double the extension cord, about
3cm from the end.
Lead the loop through the hole on
the rear safe guardand hook the
loop over the cord strain relief.
Gently pullon the cord to ensure
that it is firmly attached.
Connect to main supply
