The factory set range is 25-1/2”. Sensors in the wash closet models are pointed 15 degrees up,
while urinal sensors are pointed 15 degrees down.
A
B
C
CALIBRATE THE SENSOR
A.
Remove the protective film covering the Sensor Eye.
B. Test the Sensor by standing in front the Flushometer for about 10 seconds, then stepping away
from the Sensor.
C. You should hear a click as the Solenoid actuates, and see a red-light flash in the Sensor Eye.
16
C
D
B
A
1/2 TURN
TIGHTEN CONNECTIONS
A. Using a Flat Tip Screwdriver, slowly open the Control Stop by about ½ turn. A flush sequence
should begin immediately.
B
. Use this time to check for leaks or any loose connections.
C
. Continue to loosen the Control Stop Adjustment Screw until desired flush sequence is achieved.
D
. Test the Flushometer by activating the Sensor, or by pressing the manual override button for
1 second.
• A flush sequence should begin again.
• Continue to operate the Flushometer until desired flow is achieved, it may take a few
actuations for the flushometer to become hydraulically balanced, this is normal.
17
REINSTALL CONTROL STOP COVER
Reinstall the Control Stop Cover using the included 2.5mm Hex Key Wrench.
18
CALIFORNIA PROPOSITION 65
CALIFORNIA PROPOSITION 65:
WARNING:
This product can expose you to chemicals including lead, which is known
to the State of California to cause cancer and birth defects or other reproductive harm.
For more information go to www.P65Warnings.ca.gov.
Wash hands after installation, repair, or removal of this product.
PRODUCT WARRANTY
This product is warranted to be free of defects in material and workmanship for the period listed
below from the date of installation.
Consumer/Residential: Limited Lifetime Warranty
Commercial Use: 5 Year Limited Warranty
Speakman warrants to its purchasers only (“Buyer”) that goods are sold free from defects in materials and
workmanship and conform to Speakman’s specifications at the time of manufacturing, provided the goods
are properly installed and maintained. Buyer’s sole and exclusive remedy for any goods that may prove to
have had a non-conformance within the Warranty Period shall be, at Speakman’s sole option, the repair or
replacement of the non-conforming goods. For additional information please go to www.speakman.com.
