LUBRICATE VALVE BODY O-RING
Remove protective covering from the Valve Body Inlet. Slide the Nut and Locking Ring towards the
Valve Body to reveal the O-ring. Lubricate the O-ring with water.
10
B
A
C
NOTE: Dry connections only! Do NOT use any thread sealant!
INSTALL VALVE BODY
A.
Insert the Valve Body into the Control Stop.
B.
Align the Valve Body directly over the Vacuum Breaker tubing, adjusting the Valve Body
horizontally along the connection to the Control Stop as needed to properly align it. Loosely make
threaded connections.
C.
Verify correct alignment with the Vacuum Breaker tubing. It may be necessary to cut the Vacuum
Breaker tubing to length.
NOTE:
If you are cutting the vacuum breaker tube to size, consult local plumbing codes to ensure
that the critical line is properly located above the fixture. Typically, the critical line is 6” above the
fixture.
11
C
B
A
TIGHTEN CONNECTIONS
Tighten connections in the following order using a Strap Wrench. Do NOT use Toothed Wrench on
any connections as this will damage the finish.
A.
Tighten the connection between the Valve Body and Tailpiece Assembly.
B.
Tighten the connection between the Valve Body and Control Stop.
C.
Tighten the connection between the Tailpiece Assembly and Spud Nut.
12
C
A
B
E
D
ACCESS BATTERY BOX
A.
From behind the Valve Body, loosen, but do not remove the Set Screw with the included 2.5mm
Hex Key Wrench.
B.
Lift off the Valve Body Cover.
C.
Disconnect the
BLACK
wire connection to the Solenoid.
D.
Remove the Battery Box from within the Valve Body Cover.
E.
Disconnect the
RED
wire connection between the Sensor Eye and Battery Box.
13
B
A
INSTALL BATTERIES
A.
Use a Phillips Head Screwdriver to remove the Battery Box Lid.
B.
Install the Batteries per the orientation shown on the Battery Box.
C.
Re-assemble the Battery Box while taking care to properly align the tabs in the Lid with the
notches in the Box.
14
C
E
D
A
B
The sensor eye can point in any direction, adjust the position according to the environment
REASSEMBLE VALVE BODY COVER
A.
Connect the
RED
wire connection between the Sensor Eye and Battery Box.
B.
Reinstall the Battery Box into the Valve Body Cover.
C.
Connect the
BLACK
wire connection to the Solenoid.
D.
Reinstall the Valve Body Cover while taking care to properly tuck the wiring into the Valve Body Cover.
E.
From behind the Valve Body, secure the Set Screw with the included 2.5mm Hex Key Wrench.
15
