SoundSource Owner’s Manual
Page 7
CONNECTING THE SOUNDSOURCE
(See Diagram 7)
1.
Power
Connects the Power Cable to the SoundSource.
(See Chart A)
2.
Left/Right Speakers (8
Ω
)
Connects the left and right front speakers. Be sure to
observe proper polarity, (+) to (+) and (-) to (-).
3.
Remote Out
Connects IR out control signal for optional Aux 1 and Aux 2
components. For short IR and audio leads, use the enclosed
SIR-1.0 Interface Lead
(see page 18)
. For long length IR and
audio lead applications, use this jack with the optional SSL-
A and SSL-B accessories (sold separately).
This jack cannot
support SIR-1.0 and SSL-A/B applications simultaneously.
4.
±15V DC
Powers the optional SSL-B accessory. If the SSL-B is not
being used, this jack can be utilized as a Voltage Trigger for
SpeakerCraft’s Big Bang amplifiers with a series 1k
Ω
resistor.
For more details, contact SpeakerCraft Technical Support.
5.
FM Antenna
For connecting the supplied 75
Ω
FM antenna or external
FM antenna.
6.
AM Antenna
For connecting the supplied AM antenna.
7.
Audio Out (L/R)
For connecting to a separate audio power amplifier.
NOTE:
This is a fixed output.
8.
Audio In (Aux1)
For connecting an optional audio component.
9.
Audio In (Aux2)
For connecting an optional audio component.
CONNECTING THE POWER SUPPLY
1.
Power Cable
(See Diagram 8)
Connects the Power Cable to the Power Supply.
(See Chart A)
2.
Power Switch
(See Diagram 9)
Turns SoundSource system power supply on and off.
Diagram 7:
Bottom of SoundSource
Diagram 8:
Back of Power Supply
Diagram 9:
Front of Power Supply
Chart A
Legend on
SoundSource &
Power Supply
+28VDC
SoundSource
Cable Color
Red
Gauge of Stranded Wire
To Use If Not Using
SoundSource Cable
14
#
1
A GND
Blue
14
2
-28VDC
Black
14
3
+12VDC
White
16
4
D GND
Green
16
5
POWER DET
Yellow
16
6
Reserved for
IR Remote Out GND
Black
22
—
Reserved for
IR Remote Out Signal
Green
22
—
